Using The Ir Remote; Storing A Preset Using The Remote; Clearing A Preset Using The Remote - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

Using the IR Remote

The IR remote provides basic camera control.
What do you need to do?
Power on or standby
Select the camera to control (if this
remote controls more than one)
Discover the camera's IP address
Move the camera
Make left and right arrows behave
intuitively
Move the camera to a preset
position
Store a preset
Clear a preset
Adjust for excess light behind the
camera's subject
Focus the camera
Zoom in (tele) or out (wide)
For information about configuring the camera to respond to the remote as camera 1, 2, or 3, see
Settings.

Storing a Preset Using the Remote

Position the camera. Then hold down the Preset button and press one of the numbered preset buttons.

Clearing a Preset Using the Remote

Press and hold the Reset button while pressing the preset number you want to clear.
Button(s)
Power (green button at top right)
Camera Select buttons 1 through 3
(second row of buttons)
Data Screen button (top left) overlays IP
and MAC addresses on video output. Press
again to dismiss.
Arrow buttons and Home button (dark red)
Std Pan directions are from the camera's
point of view, Rev Pan reverses this.
Position Preset buttons 1 through 6
(bottom two rows)
Preset button + a numbered Position
Preset button
Reset button + a numbered Position
Preset button
Back Light button (top center)
Auto Focus button (near arrow buttons)
Manual Focus buttons Near and Far
(below Zoom Speed buttons)
Zoom Speed buttons (light gray) - Slow T
and W, Fast T and W for telephoto (zoom
in) and wide-angle (zoom out) modes
45
Additional