Serial Command Reference; Color And Light Management Commands - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

Serial Command Reference

The Vaddio Serial Control Protocol is similar to the Sony
with several popular control devices. Not all VISCA commands are supported, and there are Vaddio-
specific commands in the following command and inquiry lists.
The RoboFLIP 30 HDBT camera can accept these commands via the HDBaseT connection with a
OneLINK device, or from a compatible third-party controller using VISCA Over IP. (See
Over IP Access.)
The Vaddio RS-232 Serial Control Protocol is available if the camera is installed with a OneLINK device. It
®
is similar to the Sony VISCA command set in order to be compatible with several popular control devices.
Not all VISCA commands are supported, and there are Vaddio-specific commands in the following
command and inquiry lists.
Be sure the camera is set to the same baud rate as the controller or other device originating the commands.
See Additional Settings.

Color and Light Management Commands

Command Set
CAM_WB Auto
Manual
Corresponds to camera ccu set auto_white_balance in Telnet API.
CAM_RGain Reset
Up
Down
Direct
Corresponds to camera ccu set red_gain in Telnet API.
CAM_BGain Reset
Up
Down
Direct
Corresponds to camera ccu set blue_gain in Telnet API.
CAM_AE Auto
Manual
Corresponds to camera ccu set auto_iris in Telnet API.
CAM_Shutter Reset
Up
Down
Direct
Command Command Packet
8x 01 04 35 00 FF
8x 01 04 35 05 FF
8x 01 04 03 00 FF
8x 01 04 03 02 FF
8x 01 04 03 03 FF
8x 01 04 43 00 00 0p 0q FF
8x 01 04 04 00 FF
8x 01 04 04 02 FF
8x 01 04 04 03 FF
8x 01 04 44 00 00 0p 0q FF
8x 01 04 39 00 FF
8x 01 04 39 03 FF
8x 01 04 0A 00 FF
8x 01 04 0A 02 FF
8x 01 04 0A 03FF
8x 01 04 4A 00 00 0p 0q FF
®
VISCA command set in order to be compatible
Normal auto
Manual control mode
Manual control of red gain
pq = red gain (00h – FFh)
Manual control of blue gain
pq = blue gain (00h – FFh)
Auto exposure mode
Manual control mode
Shutter setting
pq = shutter position (00h – 15h)
See
CAM_Shutter Command
66
Enabling VISCA
Comments
Shutter Speed Values –