System Factory-Reset; Telnet Information And Session Management Commands; Help - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

system factory-reset

Gets or sets the factory reset status. When the factory reset status is on, the system resets to factory
defaults on reboot.
Synopsis system factory-reset { get | on | off}
Options get
on
off
>system factory-reset get
Examples
factory-reset (software):
factory-reset (hardware):
OK
>
Returns the factory reset status.
This evaluates the most recent system factory-reset on or off command, if
one has been received, then reads the rear panel DIP switches and returns the
status on if they are all in the down position.
>system factory-reset on
factory-reset (software):
factory-reset (hardware):
OK
>
Enables factory reset upon reboot.
Note
This command does not initiate a factory reset. The factory reset takes place on the
next reboot.

Telnet Information and Session Management Commands

The following commands are available for Telnet help and session management:
history
n

help

n
exit
n
help
Displays an overview of the CLI syntax.
Synopsis help
Example
help
Returns the camera's current factory reset
status.
Enables factory reset on reboot.
Disables factory reset on reboot.
off
off
on
off
64