Camera Preset - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

camera preset

Moves the camera to the specified preset, or stores the current camera position and optionally CCU
information, either with or without specifying that Tri-Synchronous Motion is to be used when moving to this
position.
Note
This command corresponds to the CAM_Memory commands in the RS-232 command set.
Synopsis camera preset { recall | store } <1 – 16> [tri-sync <1 – 24>] [save-ccu]
Options recall <1 – 16>
store <1 – 16>
tri-sync <1 – 24>
save-ccu
Examples >camera preset recall 3
OK
>
Moves the camera to preset 3.
>camera preset store 1
OK
>
Saves the camera's current position as preset 1.
>camera preset store 4 tri-sync 15
OK
>
Stores the camera's current position as preset 4. The camera will use Tri-
Synchronous Motion at speed 15 when it is recalled to this preset.
>camera preset store 2 save-ccu
OK
>
Stores the camera's current position as preset 2. The camera applies the current
CCU settings when it is recalled to this preset.
Moves the camera to the specified preset,
using Tri-Synchronous Motion if this was saved
with the preset. If CCU information was saved
with the preset, the camera switches to the
CCU setting associated with the preset.
Stores the current camera position as the
specified preset.
Optional: Specifies that the camera uses Tri-
Synchronous Motion to move to this position,
using the specified speed.
Optional: Saves the current CCU settings as
part of the preset. If not specified, the last color
settings are used when recalled.
53