Adjusting And Installing Adjustable Stud Chucks - Soyer BMS-9 Operating Instructions Manual

9.2

Adjusting and installing adjustable stud chucks

Adjustable stud chucks must be set to the length of the welding stud and, if necessary,
to the gun size.
The standard stud chuck can hold studs with a length of up to 35 mm.
For welding guns with a short housing (e.g. PS-1K
or PS-0K), it may be necessary to shorten the stop
screw of longer welding studs.
When the adjusting screw is too long, the stud
chuck cannot be fully inserted into the gun or the
stud lift cannot be properly executed during
welding.
Adjusting the stud chuck
Adjusting adjustable stud chucks
Step 1:
Step 2:
Step 3:
32
Select the stud chuck according to the required stud diameter.
Insert the stud into the stud chuck.
Adjust the stop screw so that the top of
the flange of the stud sits between 1.5
mm and 3 mm above the stud chuck
when it touches the screw.
Operating instructions Soyer Bolzenschweißtechnik