Measure Mode - Rigol DS8000-R Series User Manual

RIGOL
AX: indicates the X value at Cursor A.
⚫
AY: indicates the Y value at Cursor A.
⚫
BX: indicates the X value at Cursor B.
⚫
BY: indicates the Y value at Cursor B.
⚫
△X: indicates the horizontal spacing between Cursor A and Cursor B.
⚫
△Y: indicates the vertical spacing between Cursor A and Cursor B.
⚫
1. Adjust Cursor Position
Click AX to adjust the X value at Cursor A.
⚫
Click BX to adjust the X value at Cursor B.
⚫
Click AY to adjust the Y value at Cursor A.
⚫
Click BY to adjust the Y value at Cursor B.
⚫
Click More → ABX, then drag or scroll with the mouse to adjust the X value
⚫
at Cursor A and the X value at Cursor B simultaneously.
Click More → ABY, then drag or scroll with the mouse to adjust the Y value
⚫
at Cursor A and the Y value at Cursor B simultaneously.
During the adjustment, the measurement results will change accordingly. The
adjustable range is limited within the screen.
2. Display Lissajous Legend
This oscilloscope provides the Lissajous schematic diagram under different
frequencies and phase deviation, as shown in Figure 6-4. Click More →
Lissajous, then the Lissajous schematic diagram is displayed.
Frequency ratio
between two signals

Measure Mode

Click Mode to select "Measure". In this mode, the cursor position for measurement is
displayed.
6-44
Figure 6-4 Lissajous Schematic Diagram
Chapter 6 Operations and Measurements
Phase deviation
between two signals
DS8000-R User Guide