Rigol DS8000-R Series User Manual page 296

RIGOL
Name Input Area Chinese Character Selection Area Pinyin Input Area Virtual Keypad
Go to Previous
Page
Upper/Lower
Case Switch
Input Method
Switch
1. Chinese Input Method
If the current input method is "中/繁/En", please go to Step 2. If the current
input method is "En/中/繁" or "繁/En/中", click the input switch key to switch to
"中/繁/En". "中" is located first and highlighted.
2. Clear the Pinyin Input Area and Name Input Area
If there is no character in the "Pinyin Input Area" and "Name Input Area", please
go to Step 3. If there are characters in the "Name Input Area" and "Pinyin Input
Area", click to select the delete key
input area in order.
3. Input the First Chinese Character "文"
1) Input the pinyin "wen" in the "Pinyin Input Area"
Click to select the first letter "w" in the pinyin "wen" to input "w" in the
"Pinyin Input Area". Use the same method to input the remaining letters
"en" in the pinyin "wen". After finishing the input, the Chinese characters
available are displayed in the "Chinese Character Selecting Area".
2) Select the desired Chinese character from the "Chinese Character Selecting
Area"
Click to select "文", and then "文" is input in the "Name Input Area". If the
Chinese character is not found in the current page, click
next page until you find the desired character.
4. Input the Other Characters
Refer to Step 3 and use the same method to input the remaining Chinese
characters "件名" in sequence.
5. Modify or Delete the Unwanted Characters that Have Been Entered
When inputting the filename, you can modify or delete the filename characters
input in the "Name Input Area" as well as delete the pinyin characters input in
18-10
Chapter 18 Store and Load
to delete all the characters in the name
Go to
Next Page
to go to the
DS8000-R User Guide