Rigol DS8000-R Series User Manual page 313

Chapter 19 System Utility Function Setting
Disconnected!
⚫
DHCP Config Failed!
⚫
Read Status Fail!
⚫
Connected!
⚫
Invalid IP!
⚫
IP lost!
⚫
Please wait...
⚫
IP Configuration Type
The configuration type of the IP address can be DHCP, Auto IP, or Static IP. For
different IP configuration types, the configurations for IP address and other network
parameters are different.
DHCP
Click IP Config Type to select "DHCP". When DHPC is valid, the DHCP server in the
current network will assign the network parameters (e.g. IP address, Subnet,
Gateway, and DNS) for the oscilloscope.
Auto IP
Click IP Config Type to select "Auto IP". In auto IP mode, the oscilloscope will get
the IP address (ranging from 169.254.0.1 to 169.254.255.254) and the subnet mask
(255.255.0.0) automatically according to the current network configuration. Only
when "DHCP" is not selected or failed to be connected, can "Auto IP" be valid.
Static IP
Click IP Config Type to select "Static IP". Note: when this type is valid, you need to
disable DHCP and Auto IP manually. At this time, the "IP", "SubMask", "Gateway",
and "DNS" menu items are added. Thus, you can self-define the network parameters
(e.g. IP address) of the oscilloscope.
1. Set IP Address
The format of the IP address is nnn.nnn.nnn.nnn. The range of the first segment
(nnn) of the address is from 0 to 255 (except 127); wherein, the valid range is
from 0 to 223. The range for the other three segments is from 0 to 255. You are
recommended to ask your network administrator for an IP address available.
Click IP, and then the numeric keypad is displayed. Use the numeric keys to
input the desired IP address. This setting will be saved to the non-volatile
memory; if "Power On" is set to "Last", then DHCP and Auto IP are disabled at
the next power-on. The oscilloscope will load the preset IP address
automatically.
DS8000-R User Guide
RIGOL
19-3