Table of Contents
Advertisement
RIGOL
To Replace the Fuse
If you need to replace the fuse, use only the specified fuse (AC 250 V, T3.15 A; 5.2
mm× 20 mm) and perform the following operations (as shown in Figure 1-4):
1． Turn off the instrument, cut off the power and remove the power cord.
2． Insert a slotted screwdriver into the slot of the fuse holder to pry it out.
3． Take out the fuse.
4． Replace the old fuse with a specified fuse.
5． Install the fuse holder.
WARNING
To avoid electric shock, please ensure that the instrument has been turned
off, the power source has been cut off, and the fuse to be used conforms
to the fuse rating.
To Connect the Probe
RIGOL provides the passive probe and the active probe (required to be purchased
by yourself if necessary) for DS8000-R series. For specific probe models, please refer
DS8000-R Series Datasheet
to
please refer to the specified Probe User Guide.
Connect the passive probe:
1.
Connect the BNC terminal of the probe to an analog channel input terminal of
the oscilloscope on the front panel, as shown in Figure 1-5.
2.
Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
1-6
Figure 1-4 To Replace the Fuse
. For detailed technical information of the probes,
Chapter 1 Quick Start
Fuse Holder
Fuse
DS8000-R User Guide
Advertisement
Table of Contents
