Table of Contents
Advertisement
Chapter 19 System Utility Function Setting
RIGOL
MAC Address
For each oscilloscope, the MAC address is unique. When assigning the IP address for
the oscilloscope, the system uses the MAC address to identify the instrument.
VISA Address
Displays the VISA address currently used by the oscilloscope.
Web Control Information
Displays the user name and password for network configuration of the oscilloscope
through the LXI webpage.
Tip:
Connect the oscilloscope to the local area network. Start up Ultra Sigma, and
then right-click the resource name and select "LXI-Web" to load the LXI webpage.
You can also directly input the IP address of the oscilloscope into the address bar of
the browser to load the LXI webpage.
To Set mDNS
Click mDNS continuously to enable or disable the multicast Domain Name System
(mDNS). This system is used to provide the function of DNS server for service
discovery in a small network without a DNS server.
To Set Host Name
Click Host Name to input the host name. For the host name input method, refer to
relevant descriptions in "To Create a Folder".
To Set the GPIB Address
Before using the GPIB bus to control the oscilloscope, use the USB-GPIB interface
converter (an option that requires to be ordered separately) to extend the GPIB
interface, and then use the GPIB cable to connect the instrument to the PC.
Click on the function navigation icon
at the lower-left corner of the screen to
open the funciton navigaiton. Click on the Utility icon
to enter the "Utility"
setting menu. Click IO → GPIB to set the GPIB address. Use the pop-up numeric
keypad to input the GPIB address. Its settable range is from 1 to 30. By default, it is
1.
DS8000-R User Guide
19-5
Advertisement
Table of Contents
