Table of Contents
Advertisement
Chapter 1 Quick Start
Parameter Setting Method
You can set the parameters of DS8000-R series through the Web Control or the
externally connected display device/mouse/keyboard. The common parameter
setting method is shown as follows:
In the numeric keypad, click to select the value or the unit in the numeric keypad.
You can also use the externally connected keyboard to input the parameter value.
After you input all the values and select the desired units, the numeric keypad is
turned off automatically. This indicates that you have completed parameter setting.
Besides, after you have input the values, you can also click OK directly to close the
numeric keypad. At this time, the unit of the parameter is the default unit. In the
numeric keypad, you can also perform the following operations:
Delete the parameter value that has been input.
⚫
Set the parameter to a maximum or minimum value (sometimes, the maximum
⚫
or minimum value are the specified one for the current state).
Set the parameter to a default value.
⚫
Clear the parameter input field.
⚫
Tip
The above method is commonly used for the parameter settings of the
oscilloscope. For other methods of parameter settings, refer to details in relevant
chapters.
DS8000-R User Guide
Figure 1-14 Numeric Keypad
RIGOL
Parameter
Input Field
Delete key
Max. value
Min. value
Default
Clear key
1-21
Advertisement
Table of Contents
