Phoenix Contact EV Charge Control Basic User Manual page 55

Table 9-2 Register assignment
Type Address Value
Hold- 2000 16 bits
ing
2001 16 bits
4000 16 bits
4001 16 bits
106377_en_04
Access Memory
Read –
Read –
Read/write Retentive
Read/write Retentive
Function
Configuration switch S1
Configuration switch S2
Configuring the enable
charging process function via
input EN or Modbus registers
Switching on the PWM signal
if all other conditions required
are met.
Configuring external release
via input XR or Modbus regis-
ters
Setting status F (according to
IEC 61851-1) if charging sta-
tion is not available
Modbus description
Coding
Binary, 1 bit per DIP switch
Binary, 1 bit per DIP switch
Integer
0: Charging always enabled
1: Charging enabled if input EN =
ON (default)
2: Charging enabled in the event
of a pulsed signal at input EN,
reset upon next pulse
3: Charging enabled if value 1 is
written to register 20000.
Charging not enabled (PWM
OFF) if value 0 is written to regis-
ter 20000.
Integer
If S1/DIP 2 = OFF:
0: Always available
(Default, if S1/DIP 2 = OFF, other
values have no effect)
If S1/DIP 2 = ON:
1: Available if XR = ON, status F
if XR = OFF
(Default, if S1/DIP 2 = ON)
2: Available if value 1 is written to
register 20001. Status F if value 0
is written to register 20001.
PHOENIX CONTACT
55 / 68