Special Features In Active Profibus ® Mode; General; Displays; Leds On The Profibus ® Module - ProMinent DULCO flex Control Installation And Configuration Manual

Special features in active PROFIBUS
4
Special features in active PROFIBUS

4.1 General

4.2 Displays

Operating display
Status display
Main display
4.3 LEDs on the PROFIBUS
LEDs
Flashing red and green at a
slow rhythm
Lit red
Lit green
6
® mode
INFORMATION!: The pump cannot be manually set or programmed in
PROFIBUS ® mode. To do so, switch the PROFIBUS
You can move between the continuous displays at any time, as in the
n
other operating modes. This does not affect the operation of the
pump.
The settings from other operating modes are carried over when
n
switching over to PROFIBUS
via the PROFIBUS
INFORMATION!: The settings only apply as long as the pump is con‐
nected to the PROFIBUS
Only the total speed and the total number of litres continue to be
counted and saved.
If the pump is switched to PROFIBUS
n
can only be restarted using the PROFIBUS
There are additional identifiers in the operating display when PROFIBUS
mode is running.
Stop PROFIBUS
The master has sent the pump a corresponding telegram.
Connection error: if the pump loses its connection to the PROFIBUS
(for instance as soon as the PROFIBUS
symbol and the
module
®
Cause
Connection between the PROFIBUS
the hardware or software version of the pump may not be suitable for PROFIBUS
No connection to the PROFIBUS
Pump in cyclic operation
mode
®
mode. By contrast, the settings made
®
® are not saved.
.
®
® mode, the pump will stop and
.
®
® : the pump has been stopped using PROFIBUS
is stopped), then the error
®
symbol flash on the main display.
® module and pump has been disrupted;
®
'inactive' .
® to
®
® .
®
®