Replacing A Danfoss Compressor Drive - Huawei NetCol5000-A035 User Manual

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm Width)
Step 8 Reinstall the drive by performing
Step 9 Power on the NetCol5000-A, choose Maint > Diagnostic Mode > Enter on the
home page, start the compressor, and check that the compressor works properly.
Then exit the diagnostic mode.
----End

6.5.5.2 Replacing a Danfoss Compressor Drive

Prerequisites
Before checking and maintaining the NetCol5000-A, ensure that the power supply
to the NetCol5000-A is disconnected and the drive has been placed without
primary power supply for 10 minutes. Otherwise, electric shocks may occur.
●
●
Procedure
Step 1 Open the rear door. Remove the filters, and switch off the general power input
breaker QF1 and compressor circuit breaker QF3.
Step 2 Open the front door.
Step 3 Open the U-shaped protection sheet metals of the compressor drive by using
Phillips screwdriver and take it out.
Step 4 Undo the buckle at the groove of the lower baffle plate (shown by 1 in
6-16) using a flat-head screwdriver. Remove the baffle plate and control
communications terminals (terminals with jumpers 12–27 and 12–37 respectively).
Issue 17 (2020-10-22)
D ANGER
Recommended materials: Flat-head screwdriver, Phillips screwdriver, socket
wrench (M3 and M6), diagonal pliers, coils, new compressor drive.
Preparations: Switch off the outside main power input.
Copyright © Huawei Technologies Co., Ltd.
6 System Operation and Maintenance
Step 3 to Step 7 in a reverse order.
Figure
216