Huawei NetCol5000-A035 User Manual page 112

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm Width)
Paramete
r
L1/L2
linkage
humdity
Note: In the ACC V100R002C00 software versions, DIP switch is replaced by the
Teamwork CAN resistor enable parameter. If teamwork is not set onsite,
remain the parameter in OFF. If teamwork is set, change the parameters of the
first and last units to ON, and remain the others in OFF.
Step 3 Complete the teamwork settings for all the smart cooling products by performing
Step 1
Step 4 On the home screen of any teamwork controlled smart cooling product, tap
If the teamwork control succeeds, the teamwork topology of the smart cooling
product in the group is displayed, as shown in
the note for the screen.
Figure 4-12 Teamwork topology
Table 4-7 Note for the screen
No.
1
2
Issue 17 (2020-10-22)
Description
Humidity setpoint in L1/L2
linkage.
and Step 2.
Parameters
On/Off/NA
01, 02, 03
Copyright © Huawei Technologies Co., Ltd.
Configuration Principle
Target humidity
controlled in the micro-
module. The parameter
can only be modified on
the ECC WebUI and
cannot be modified on
the smart cooling
product screen.
Figure 4-12.
Note
On indicates the smart cooling product is
started and Off indicates the opposite. NA
indicates the smart cooling product is offline.
Indicates the device address. 01 is the master
one and the rest are all slave ones.
NOTE
If the master one offline, the teamwork networking
failed.
4 ACC Introduction
Default
Value
45.0%RH
Table 4-7 describes
102
.