Installing The Mini Perc Card Module - Dell EMC PowerEdge XE7420 Installation And Service Manual

Steps
1. Loosen the captive screw and remove the three screws securing the mini card module.
2. Lift the mini PERC module from the system board.
NOTE: When mini PERC module is released out, mini PERC riser may be attached to system board, if the mini PERC
riser is attached to system board then remove it and attach to the mini PERC adapter board.
Figure 34. Removing the mini PERC module
3. Loosen the two captive screws and remove the mini PERC cable.
4. Disconnect the mini PERC battery cable.
Next steps
Replace the mini PERC module

Installing the mini PERC card module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Insert the mini PERC card module into the system board. Press until the internal PERC riser fits into place.
2. Fix the mini PERC module by three screws and one captive screw.
.
Safety instructions.
Before working inside your system.
Installing and removing system components 67