– Pull trim -2- downwards in the middle -arrow- out of mounting
-1-.
– Push the trim rearwards.
– Run solar panel to zero position.
To avoid wind noise, adjust the solar panel height front and rear
as shown in the illustration.
Front panel adjustment:
-a- = 0...1 mm lower than roof outer skin
-Arrow- = direction of travel
Rear panel adjustment:
-b- =0...1 mm higher than roof outer skin
-Arrow- = direction of travel
– Tighten screws of solar panel 5 Nm.
2.7
Checking parallel running of solar panel
– Open sliding/tilting sunroof about 10 cm rearwards.
– Pull trim -2- downwards in the middle -arrow- out of mounting
-1-.
– Run solar panel to zero position.
– Push the trim rearwards.
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
2. Sliding/tilting sunroof with solar panel (Webasto)
201