Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
♦ Hot-air blower - V.A.G 1416-
♦ Adhesive strip remover - VAS 6349-
15.3
Fitting instructions
♦ Before removing the lettering, heat it with a hot air blower -
V.A.G 1416- .
♦ If lettering is fitted for the first time on a new vehicle or on newly
painted surfaces, observe the procedure in ⇒ Workshop man‐
ual "Paint"; ⇒ Paintwork repairs; ⇒ Paint finish; ⇒ Mouldings &
film .
♦ If lettering is removed and reinstalled, only use adhesive re‐
mover - D 002 000 10- to remove the adhesive remains.
♦ Remove existing adhesive residue of adhesive tape using ad‐
hesive strip remover - VAS 6349- .
♦ Ensure that the adhesive surfaces are free of dust and grease.
♦ The lettering must be bonded in place immediately after clean‐
ing.
♦ Remove backing only immediately before installation.
♦ Working temperature is approx. 21°C.
♦ Lettering cannot be removed without damage.
15.4
Rear lettering - dimensions
15.4.1
Rear lettering (saloon)
Note
When fitting the lettering, observe the fitting notes
458
Rep. gr.66 - Exterior equipment
⇒ page 458