Removing And Installing Door Handle With Access And Start Authorisation - Volkswagen Passat 2011 Workshop Manual

Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
– Pull out door handle -2- towards rear slightly -arrow a- from
support for mounting bracket.
– Swing door handle around in direction of -arrow b-.
– Remove door handle perpendicular to door -arrow c- from
mounting bracket -1-.
2.7.2 Installing
– Place door handle -1- perpendicular to door -arrow a- in
mounting bracket -2-.
– Swivel door handle -1- into door -arrow b-.
– Slide door handle forwards slightly -arrow c- in mounting
bracket mounting.
Note
Door handle stops in "open" state. Try not to push door handle in,
as otherwise mounting bracket will break off and a removed door
handle can no longer be installed. The door handle comes in con‐
tact with the door after the lock cylinder housing is fitted.
Install lock cylinder housing
• It is essential that the function then be checked with the door
open.
2.8 Removing and installing door handle
with access and start authorisation
Note
Removal and installation are described only for the right door
♦
handle. The removal and installation procedure for the left
door handle is basically the same.
Door handle stops in "open" state. Try not to push door handle
♦
in, as otherwise mounting bracket will break off and a removed
door handle can no longer be installed.
2.8.1 Removing
– Remove lock cylinder housing
108
Rep. gr.57 - Front doors, door components, central locking
⇒ page 107 .
⇒ page 106 .