Volkswagen Passat 2011 Workshop Manual page 304

Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
– Set hole puncher in position with bolt head -1-, washer -2- and
thrust bearing -3- from inside bumper cover -5-.
– Screw on punch -4-, not quite as far as bumper cover.
– Press punch -4- against bumper cover.
– Tighten hole puncher -1-.
Note
Do not permit the punch -4- to turn on the paint of the bumper cover.
– Pull punch -4- through material of bumper cover -5- -arrows-
by turning bolt head -1-.
– Remove hole punch and make next holes.
– Thoroughly clean bumper cover and bracket with cleaning sol‐
ution.
Note
Approx. 1 cm of adhesive from tip should not be applied.
294
Rep. gr.63 - Bumpers