Note
The work steps below are first carried out on one side and the components must then be held in position. After
that, the parts on the other side are assembled by a second mechanic.
– The recess -arrow a- in sun blind slide -1- must be aligned with
guide -arrow a- on cable -4-.
– The openings -arrows b- of steel strap -2- must be aligned with
guides -arrows b- in sun blind slide -1-.
Specified torques
Cover cap bolt 2 Nm
Note
After installation, check sun blind for balanced operation and ease of movement. To do this, move by hand
♦
sun blind drive on motor using a commercially available hexagon key and avoid wrinkling and deformation
of sun blind fabric.
Move sun blind to rearmost position by hand. The adaptation starts at the rearmost position.
♦
Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
3. Panorama sliding sunroof (Arvin-Meritor)
247