Xilinx Virtex-7 VC7222 User Manual page 18

Chapter 1: VC7222 Board Features and Operation
The fan power connections are detailed in
Table 1-5: Fan Power Connections
Figure 1-11
X-Ref Target - Figure 1-11
Virtex-7 FPGA
The VC7222 board is populated with the Virtex-7 XC7VH580T-G2HCG1155E FPGA at U1
(callout 1,
Overview (DS180)
FPGA Configuration
The FPGA is configured via JTAG using one of the following options:
•
•
•
The VC7222 board comes with an embedded USB-to-JTAG configuration module (U57)
which allows a host computer to access the board JTAG chain using a standard A to
micro-B USB cable. Alternately, the FPGA can be configured via System ACE from a Secure
Digital (SD) memory card installed in J30 (see
Switches, page
chain using one of Xilinx's configuration cables—Platform Cable USB, Platform Cable USB
II or Parallel Cable IV (PCIV).
18
Send Feedback
Fan Wire Header Pin
Black J121.1 - GND
Red J121.2 - 12V
Blue J121.3 - NC
shows the heats ink fan power connector J121.
Figure 1-11: Heatsink Fan Power Connector J121
Figure 1-2). For further information on Virtex-7 FPGAs, see 7 Series FPGAs
[Ref 5].
USB JTAG connector (callout 9,
System ACE SD (callout 11,
JTAG cable connector (callout 10,
20). Finally, a JTAG connector (J1) is available to provide access to the JTAG
www.xilinx.com
Table 1-5:
UG965_c1_11_070313
Figure 1-2)
Figure 1-2)
Figure 1-2)
System ACE SD Configuration Address DIP
VC7222 Transceiver Characterization Board
UG965 (v1.4) February 11, 2015