Table 080-40: Service Mode Summary, G 2630/G 2670 - Miele G 1 Series Technical Information

G 1xxx/G 2xxx
3. Release the C (clear) button when the display lights up.
4. Immediately press the C (clear) button 3 times; on the 3rd time, hold for
at least 4 seconds.
Acknowledgement indicator:
Successful accessing of the programming mode is indicated by the LEDs,
which are all off, and Service program, in the top line of the display.
The display always indicates three parameters at a time.
Use the cursor buttons to scroll through the display.
Options:
Function
Check ID. no.
Fault memory display
Fault code deletion
Component test
Operating hours check
LED test
Buzzer test

Table 080-40: Service Mode Summary, G 2630/G 2670

Programming
Select ID number. To
return to the main menu,
press OK.
Select Fault memory. To
return to the main menu,
press OK.
Select Fault memory.
Select Delete fault
memory? with the cursor
buttons; confirm with OK.
Select Component.
Components V01 - V17
are activated via the
cursor buttons. To return
to the main menu, press C
(clear).
Select Operating hours
with the cursor buttons. To
return to the main menu,
press OK.
Select Operation. Select
B01: LED test. To return
to the main menu, press
C (Clear).
Select Operation. Select
B02: Buzzer test. To
return to the main menu,
press C (Clear).
217
Technical Information
Display
The display shows the ID numbers
of the BAE (selection-display
electronic) and SLT (control-power
electronic).
The display shows the saved fault
codes. If multiple fault codes have
been registered, they are all shown.
Alternatively, the message No fault
is displayed. See Table 080-2 for a
list of fault codes.
In the display, the option Delete
fault memory? is shown along with
the saved fault codes.
The display lists the available
components and mini-programs
with wiring diagram abbreviations.
The relevant test program starts
after 2 s (see Section 080-2.2).
The display shows the number
of operating hours.
All LEDs and the display light up.
Buzzer on.