Service; Removing The Combination Dispenser; Cable Holder Removal; Locking Plate Adjustment - Miele G 1 Series Technical Information
Hide thumbs
Also See for G 1 Series:
- Operating instructions manual (76 pages) ,
- Manual (46 pages) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
G 1xxx/G 2xxx
4
Service
4.1
Removing the Combination Dispenser
1. Remove the door outer panel. See Section 030-4.3.
2. Disconnect all dispenser plug connections.
3. Remove the retaining screws (Figure 020-11, Item 1).
4. Release the retaining clips (2 on top, 1 on bottom) and press out the
dispenser assembly.
5. After replacing the combination dispenser, check it for correct operation
using the service mode.
Figure 020-11: Combination Dispenser Removal
4.2
Cable Holder Removal
1. Remove the door outer panel. See Section 030-4.3.
2. Open the cable holder cover with a screwdriver.
3. Disconnect the ground connection to the door.
4. Loosen the clip.
5. Remove the cable holder.
4.3
Locking Plate Adjustment
Note:
Ensure that the appliance is installed perfectly level.
59
Technical Information
Advertisement
Table of Contents
Need help?
Do you have a question about the G 1 Series and is the answer not in the manual?
Questions and answers
INTAKE AND DRIAN COMES ON ALL THE TIME NEED TO READ WHAT THE CODES ARE FOR THIS UNIT G2141
For the Miele G 1 Series dishwasher model G2141, when the "Intake/Drain" light is on continuously, it typically indicates a fault condition. Based on the context, error codes like F01 or other FXX codes may be shown on the display, and the "Intake/Drain" LED may flash or stay on. Specific error codes are not directly listed for G2141 alone, but models like G2120 and G214x share similar fault indications:
- The “Intake/Drain” LED may flash.
- The time display may show FXX (e.g., F01).
- LEDs like “Wash/Rinse,” “Drying,” and “End” may flash together.
These symptoms generally suggest a fault related to water intake or drainage, such as a blocked filter, kinked hose, or faulty pump.
This answer is automatically generated