Fault Code F36: Door Lock Switch Defective; Fault Code F40: Electronic Fault; Fault Code F42: Line Frequency Registration Fault; Fault Code F47: Faulty Interface Between Selection-Display Electronic (Bae) & Control-Power Electronic (Slt) - Miele G 1 Series Technical Information
Hide thumbs
Also See for G 1 Series:
- Operating instructions manual (76 pages) ,
- Manual (46 pages) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
G 1xxx/G 2xxx
3.25
Fault Code F36: Door Lock Switch Defective
Symptom:
The drain pump is operated, and any running program is interrupted.
See Table 080-3 for model-specific fault indications.
Cause:
S4 and S80 closed at the same time.
Remedy:
Replace the comfort door closing aid; see Section 020-4.9.
3.26
Fault Code F40: Electronic Fault
Symptom:
The dishwashing program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
Cause:
The electronic has a fault that cannot be repaired by the service department
(such as a hardware fault).
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
3.27
Fault Code F42: Line Frequency Registration Fault
Symptom:
The program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
A check is carried out to ensure that the line frequency is within certain valid
ranges (50 ± 5 Hz or 60 ± 5 Hz). This fault is registered when it cannot clearly
be established which valid range is applicable.
Cause:
Main power supply not in order.
Remedy:
The main power supply should be checked by a specialist.
3.28
Fault Code F47: Faulty Interface Between Selection-Display
Electronic (BAE) & Control-Power Electronic (SLT)
Symptom:
The dishwashing program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
Cause:
Communication between BAE and SLT faulty.
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
153
Technical Information
Advertisement
Table of Contents
Need help?
Do you have a question about the G 1 Series and is the answer not in the manual?
Questions and answers
INTAKE AND DRIAN COMES ON ALL THE TIME NEED TO READ WHAT THE CODES ARE FOR THIS UNIT G2141
For the Miele G 1 Series dishwasher model G2141, when the "Intake/Drain" light is on continuously, it typically indicates a fault condition. Based on the context, error codes like F01 or other FXX codes may be shown on the display, and the "Intake/Drain" LED may flash or stay on. Specific error codes are not directly listed for G2141 alone, but models like G2120 and G214x share similar fault indications:
- The “Intake/Drain” LED may flash.
- The time display may show FXX (e.g., F01).
- LEDs like “Wash/Rinse,” “Drying,” and “End” may flash together.
These symptoms generally suggest a fault related to water intake or drainage, such as a blocked filter, kinked hose, or faulty pump.
This answer is automatically generated