Water Level Check; Figure 050-34: Filling The Salt Container In The Door; Figure 050-35: Water Level Reference - Miele G 1 Series Technical Information
Hide thumbs
Also See for G 1 Series:
- Operating instructions manual (76 pages) ,
- Manual (46 pages) ,
- Operating instructions manual (76 pages)
Table of Contents
Advertisement
Technical Information
Figure 050-34: Filling the Salt Container in the Door
Warning!
Inadvertently filling the salt container with dishwashing detergent will
damage the water softener.
Warning!
Only use water softener salt specially formulated for dishwashers. Other
salts may contain insoluble additives which can impair the water softener.
4.35
Water Level Check
1. Fully open the water supply.
2. Start the Rinse & Hold program, then wait about 3 minutes.
3. Do not cancel the program. Slowly open the door to observe the water
level in the bottom of the wash cavity.
4. If the water level is within close proximity of the filter handle (about 4
millimeters above the filter), then sufficient water has been taken in; see
Figure 050-35.
Figure 050-35: Water Level Reference
122
G 1xxx/G 2xxx
Advertisement
Table of Contents
Need help?
Do you have a question about the G 1 Series and is the answer not in the manual?
Questions and answers
INTAKE AND DRIAN COMES ON ALL THE TIME NEED TO READ WHAT THE CODES ARE FOR THIS UNIT G2141
For the Miele G 1 Series dishwasher model G2141, when the "Intake/Drain" light is on continuously, it typically indicates a fault condition. Based on the context, error codes like F01 or other FXX codes may be shown on the display, and the "Intake/Drain" LED may flash or stay on. Specific error codes are not directly listed for G2141 alone, but models like G2120 and G214x share similar fault indications:
- The “Intake/Drain” LED may flash.
- The time display may show FXX (e.g., F01).
- LEDs like “Wash/Rinse,” “Drying,” and “End” may flash together.
These symptoms generally suggest a fault related to water intake or drainage, such as a blocked filter, kinked hose, or faulty pump.
This answer is automatically generated