Miele G 1 Series Technical Information page 204

Technical Information
Options:
Note:
Some of the following parameters can also be programmed via the Settings menu.
Function
Reset
Setting the language
Setting the time of day
Format
Set manually
Setting the detergent type
Dispensed rinse aid
quantity setting
Activating/deactivating
Drying Plus
Setting the intervals for
the filter checks
Adjust Sensor wash
program
Programming
Select Reset. To restore
the standard settings,
select OK. To return to the
main menu, press Back.
Select Language.
Select a language and
confirm with OK.
Select Time of day.
Select a submenu and
confirm with OK.
Choose 24- or 12-hour
setup and confirm with
OK. Press C (clear) to go
back one level.
Set the time (seconds,
then minutes) using the +,
- buttons and confirm with
OK. Press C (clear) to go
back one level.
Select Detergent type.
Select a detergent type
and confirm with OK.
Select Rinse aid. Select a
rinse aid quantity with the
+, - buttons and confirm
with OK.
Select Drying Plus.
Select a setting and
confirm with OK.
Select Check filters.
Select a wash interval and
confirm with OK.
Select Adjust sensor
wash. Select a setting and
confirm with OK.
204
G 1xxx/G 2xxx
Display
The display reads Reset standard
settings?
The display lists the languages that
can be selected. A language must
be selected in order to return to the
main menu.
The submenus Format and Set
manually can be selected.
Display of both clock formats.
Entry request is indicated.
The display shows the selection of
available detergent types: Powder,
GEL, 2 in 1 and 3 in 1 for G 2830;
Powder, GEL and Tab for G 2832
and G 2872.
The display shows the current rinse
aid dispensing quantities: The
dispensed quantity can be set from
0 to 0.2 fl.oz. (0 - 6 mL). Standard
setting: 0.1 fl.oz. (3mL).
If the function is activated, the door
automatically moves to the drying
position at the end of the program;
see Section 080-2.7.
The display shows the intervals
available for selection. Range: 30 -
60 wash cycles.
Setting options On, Off (standard
setting). (Yes and No for G 2872).
With this parameter, Sensor wash
can be adjusted for use against
stubborn stains (if overall soiling is
moderate). If this option is selected,
the main wash temperature is
raised to 131°F, resulting in an
extended running time.