Optima - G 1202; Table 080-32: Service Mode Summary, G 118X/G 2170/G 218X - Miele G 1 Series Technical Information
Hide thumbs
Also See for G 1 Series:
- Operating instructions manual (76 pages) ,
- Manual (46 pages) ,
- Manual (14 pages)
Table of Contents
Advertisement
G 1xxx/G 2xxx
Function
Operating hours check
LED test
Buzzer test
Table 080-32: Service Mode Summary, G 118x/G 2170/G 218x
4.3.2
Optima - G 1202
Initial requirements:
1. Close the door.
2. Switch off the appliance.
Accessing:
1. Press and hold the Start/Stop button.
2. Switch on the appliance.
3. Release the Start/Stop button.
4. Immediately press the Start/Stop button 3 times; on the 3rd time, hold
until the "Start/Stop" LED flashes.
5. Release the Start/Stop button.
6. If the "Start/Stop" LED does not light up, repeat the procedure.
Acknowledgement indicator:
The "Start/Stop" LED flashes slowly (1 flash per second).
Programming
Press the Program button
3x. To display the
operating hours, press and
hold the Program button
until the "Intake/Drain"
LED lights up. Then briefly
press the Program button.
Press the Program button
4x. To start the LED test,
press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
Press the Program button
5x. To start the buzzer
test, press and hold the
Program button until the
"Intake/Drain" LED lights
up. Then briefly press the
Program button.
209
Technical Information
Display
The "Intake/Drain" LED flashes 3x
rapidly. The "SaniWash" LED's
flash pattern indicates the saved
operating hours: Each slow flash of
the "SaniWash" LED corresponds
to 1000 h and each rapid flash
corresponds to 100 h.
The "Intake/Drain" LED flashes 4x
rapidly. All LEDs light up.
The "Intake/Drain" LED flashes 5x.
Advertisement
Table of Contents
Need help?
Do you have a question about the G 1 Series and is the answer not in the manual?
Questions and answers
INTAKE AND DRIAN COMES ON ALL THE TIME NEED TO READ WHAT THE CODES ARE FOR THIS UNIT G2141
For the Miele G 1 Series dishwasher model G2141, when the "Intake/Drain" light is on continuously, it typically indicates a fault condition. Based on the context, error codes like F01 or other FXX codes may be shown on the display, and the "Intake/Drain" LED may flash or stay on. Specific error codes are not directly listed for G2141 alone, but models like G2120 and G214x share similar fault indications:
- The “Intake/Drain” LED may flash.
- The time display may show FXX (e.g., F01).
- LEDs like “Wash/Rinse,” “Drying,” and “End” may flash together.
These symptoms generally suggest a fault related to water intake or drainage, such as a blocked filter, kinked hose, or faulty pump.
This answer is automatically generated