Risk Of Injury Due To Sharp Edges And Protruding Parts; Uninstalling The Dishwasher; Service Work - Casing; B Modification History - Miele G 1 Series Technical Information
Hide thumbs
Also See for G 1 Series:
- Operating instructions manual (76 pages) ,
- Manual (46 pages) ,
- Manual (14 pages)
Table of Contents
Advertisement
G 1xxx/G 2xxx
3
Risk of Injury Due to Sharp Edges and Protruding Parts
Danger!
There may be a risk of injury due to protruding parts.
Protective goggles should be worn.
There may be a risk of injury due to sharp edges. Protective gloves should
be worn and the edge protection (mat. no. 05057680) should be used.
4
Uninstalling the Dishwasher
Before the machine is removed from its installation niche, the appliance
feet must be screwed in (for positioning, refer to the installation plan).
If this is not done the feet could become damaged.
If the machine is installed on skids, adjusting the feet is not required.
5
Service Work – Casing
Warning!
If it is necessary to tip the machine when working on its lower areas, it
may only be tilted onto its back.
The appliance must not be tilted onto its left side as this would cause
brine to run out of the salt container.
After work has been completed and the machine installed again, a short
program without load should be carried out. This is to remove any salt
residues that might be present and to prevent possible corrosion.
B
Modification History
When?
2/17/2012
8/22/2011
4/26/2011
6/10/2010
3/11/2010
2/26/2010
Who?
Jessica Naples
Jessica Naples
Jessica Naples
Jessica Naples
Jessica Naples
Jessica Naples
13
Technical Information
What?
Tech service bulletins added
Fault code F 78 corrected (page 160)
Miele WaterProof System guarantee deleted
(page 79)
Updated
Updated
Compilation for Website
Advertisement
Table of Contents
Need help?
Do you have a question about the G 1 Series and is the answer not in the manual?
Questions and answers
INTAKE AND DRIAN COMES ON ALL THE TIME NEED TO READ WHAT THE CODES ARE FOR THIS UNIT G2141
For the Miele G 1 Series dishwasher model G2141, when the "Intake/Drain" light is on continuously, it typically indicates a fault condition. Based on the context, error codes like F01 or other FXX codes may be shown on the display, and the "Intake/Drain" LED may flash or stay on. Specific error codes are not directly listed for G2141 alone, but models like G2120 and G214x share similar fault indications:
- The “Intake/Drain” LED may flash.
- The time display may show FXX (e.g., F01).
- LEDs like “Wash/Rinse,” “Drying,” and “End” may flash together.
These symptoms generally suggest a fault related to water intake or drainage, such as a blocked filter, kinked hose, or faulty pump.
This answer is automatically generated