Miele G 1 Series Technical Information page 199

G 1xxx/G 2xxx
Function
Save extras
Setting the temperature
format
Activating/deactivating
the buzzer
Activating/deactivating
the confirmation tone
Brightness adjustment
Activating/deactivating
the memory
Activating the dealer
demo mode
Resetting standard
settings
Adjusting the wash/final
rinse temperature
Water quantity
normal/increased
Activating/deactivating
sensor softener, manually
setting water hardness
Program running
time reduction
Programming
Select Save extras.
Select a setting and
confirm with OK.
Select Temperature.
Select a format and
confirm with OK.
Select Buzzer.
Select a setting and
confirm with OK.
Select Keypad tone.
Select a setting and
confirm with OK.
Select Brightness. Select
a setting using the
Dimmer and Brighter
buttons and confirm with
OK.
Select Memory. Select a
setting and confirm with
OK.
Select Dealer. Select a
setting and confirm with
OK.
Select Factory default.
To reset the parameters
(settings) modified by the
customer to their standard
settings, confirm with OK.
Select Temperatures.
Select Main wash or Final
rinse. Make a setting and
confirm with OK.
Select Water plus. Select
a setting; confirm with OK.
Select Water hardness.
Select a setting and
2
confirm with OK.
Select Shorten the
program. Make the
desired selection and
confirm with OK.
199
Technical Information
Display
This function is activated in the
standard settings. In the display,
this is signaled with the message
On. If you do not wish to save,
select Off.
The temperature can be displayed
in °C or °F as desired.
The options Off, Normal and Loud
are shown in the display.
Options: On (standard), Off.
The brightness of the display can
be set in 17 levels, with level 8 as
the standard setting. Brightness
levels are displayed in bar form.
Options: On (standard setting) and
Off. The memory function saves the
last selected program.
For options, see Section 080-
4.2.13.
The display reads Reset factory
default settings?
Options: Normal and Increased.
Increased wash temperature results
in a longer running time.
Options: Normal and Increased. If
Increased is selected, water intake
increases by 16.7 fl.oz. (500mL).
Automatic = Sensor softener
activated. The water hardness at
the installation site can also be
manually set. Water hardness
range: 1°d to 70°d (1.1 to 74.9 gpg).
For information on external water
softeners, see Section 080-4.2.14.
The display shows the options On
and Off (standard setting).
Program-dependent running time is
reduced by reducing temperatures
and/or canceling holding times.