Settings Selected During Initial Commissioning Are Not Saved; Tea Residues In "Sensor Wash" Program (Id No. -876) - Miele G 1 Series Technical Information

Technical Information
Quit the machine service mode or briefly disconnect the machine from the
power supply again or log on the machine to the RemoteVision system.
After a maximum of 1 minute, the RemoteVision system can be used again.
3.6

Settings Selected During Initial Commissioning Are Not Saved

Symptom:
After successful initial commissioning, settings that have been made (such
as language or time of day) are not saved. If the appliance is switched off
and on, the desired settings must be made again.
Cause:
These settings are only saved after the first program is completely finished
(see the operating instructions).
Remedy:
Carry out initial commissioning in accordance with the operating instructions.
3.7

Tea Residues in "Sensor Wash" Program (ID No. -876)

Symptom:
Complaints about tea residues in Sensor Wash program. It is to be assumed
that the remaining load causes little turbidity.
Cause:
Threshold values are not reached, resulting in a short program running time
(low wash temperature and no wash water exchange).
Because of the low degree of soiling in the suds, the program time is
shortened, since the wash temperature is kept low, and the wash water is not
replaced. As a result, the tea residues are not dissolved completely by the
oxygen bleach in the detergent.
Remedy:
Modify the threshold values by running the update "Improved
Cleaning of Tea Residues in Sensor Wash Program", mat. no. 06471560.
Note:
In machines starting with ID no. -984, the same result can be achieved by
selecting "Adjust Sensor Wash Program" in programming mode.
136
G 1xxx/G 2xxx