Fault Diagnosis; General Information; Programming And Service Mode Features; Water Hardness Programming - Miele G 600 Series Technical Information

Technical Information
6.0

Fault Diagnosis

6.1

General Information

Every electronically controlled Miele dishwasher has three accessible modes for
service purposes:
Programming mode
Service mode 1
Service mode 2
6.2

Programming and Service Mode Features

6.2.1

Water Hardness Programming

Note:
The water hardness value can only be programmed if the dishwasher is
programmed to the "with water softener" setting.
6.2.2

Drying Options (As Applicable)

Accessed by the customer in the programming mode for extending the duration the
turbothermic fan is on during drying.
An additional amount of time can also be programmed by a technician using service
mode 2. Refer to the model-specific timing chart for details.
6.2.3

Water Intake Duration

This setting adjusts the maximum duration the dishwasher has to fill with the proper
amount of water. The default setting is two minutes. An extended value of four
minutes can be programmed for low-pressure conditions.
Note:
Since water volume is determined by the flow meter, the dishwasher may fill in less
time than the actual programmed duration.
6.2.4

Buzzer (As Applicable)

Applies only to fully integrated (Vi) dishwashers (except Plus series). Can be used to
add an audible buzzer at the end of the program.
6.2.5

Fault Code Retrieval

Stores the last fault registered to assist in troubleshooting.
Note:
Any stored fault code must be cleared prior to performing any troubleshooting.
6.2.6

Increase Temperature

Enables a higher temperature setting during heating. Refer to the model-specific
timing chart for details.
74
G 600/G 800