Fault Code F36: Door Lock Switch Defective; Fault Code F40: Electronic Fault; Fault Code F42: Line Frequency Registration Fault - Miele G 4205 Technical Information

Technical Information
Symptom:
The drain pump is operated, and any running program is interrupted.
Cause:
The given time for extension of the automatic door lock latch from position 1
to 2, or 2 to 3 (see Section 020-2.4) is not sufficient.
Remedy:
1. Check if there is supply voltage.
2. Replace the automatic door lock latch; see Section 020-4.9.
Cause:
Given time period for new positioning exceeded.
Remedy:
1. Check if there is supply voltage.
2. Replace the automatic door lock latch; see Section 020-4.9.
3.23

Fault Code F36: Door Lock Switch Defective

Symptom:
The drain pump is operated, and any running program is interrupted.
Cause:
S4 and S80 closed at the same time.
Remedy:
Replace the automatic door lock latch; see Section 020-4.9.
3.24

Fault Code F40: Electronic Fault

Symptom:
The dishwashing program is interrupted and the drain pump is operated.
Cause:
The electronic has a fault that cannot be repaired by the service department
(such as a hardware fault).
Remedy:
Replace the electronic. See Section 100-4.5 or 100-4.6.
3.25

Fault Code F42: Line Frequency Registration Fault

Symptom:
The program is interrupted and the drain pump is operated. A check is carried
out to ensure that the line frequency is within certain valid ranges (50 ± 5 Hz
or 60 ± 5 Hz). This fault is registered when it cannot clearly be established
which valid range is applicable.
Cause:
Main power supply not in order.
Remedy:
The main power supply should be checked by a specialist.
140
G 5xxx