Setting Up A Seca 360° Proximity Connection - Seca mVSA 535 Instructions For Use Manual

5.4 Setting up a seca 360° proximity connection
178 • /
seca mVSA 535 seca mBCA 525
NOTE
• Settings you make in this dialog window are transmitted to the
seca analytics 115
manually.
• Note the user documentation for the EMR system used.
• seca Service will be pleased to assist if you have any questions
relating to interface configuration.
Use a
seca 360° proximity
patible seca measuring devices (scale, measuring rod, measuring station).
2. Measure
Workflow LED
LED-Messvorgang
3. Submit
Example display:
Beispiel-Darstellung:
seca 285
measuring station with
Messstation seca 285 mit Interface-Modul seca 452 und seca mVSA 535
seca mVSA 535
The following requirements must be met in order to connect:
• The seca measuring device is equipped with either a
interface module or with an internal interface module (in each case firm-
ware version Q2_2020_Build_615 or higher).
• The seca measuring device is connected to your LAN or WiFi network.
• The seca measuring device is configured as follows:
– Scan user ID: Required
– Scan patient ID: Required
– Confirmation of measurement on seca measuring device: Required
– Port used: Port configured for communication with the
seca connect 103
connection to the seca connect 103 software
NOTE
Information about how to configure your seca measuring device can
be found in the seca 103/452
Proceed as follows to connect the seca measuring device:
PC software ➔
Exporting patient and user data
connection to adopt measured values from com-
1. Measuring device is reserved
1. Messgerät wird reserviert
Receive
2. Messen
3. Senden
seca 452
interface module and
software (default: 22020) ➔
system instructions for use.
Empfangen
external
seca 452
Setting up a