Weight And Height - Seca mVSA 535 Instructions For Use Manual

Weight and height

72 • /
seca mVSA 535 seca mBCA 525
Modifying presets
NOTE
Your settings apply to the current measurement procedure. If you
stop the measurement procedure ➔
dure, the presets defined by the administrator become active again.
1. Ensure that no SpO sensor has been applied to the patient.
2
2. Press the SpO field.
2
The SpO settings dialog window opens.
2
The presets are displayed (in this case: Masimo SET
3. Press the desired sensitivity:
Masimo SET
Mode
Normal
Adaptive Probe Off Detection
(APOD)
Maximum
Mode
Stable
Normal
Sensitive
4. Press the Confirm button.
The dialog window closes.
The changed settings are used for the current measurement.
5. Start the SpO measurement as described in the section entitled
2
➔
Starting an SpO measurement.
2
The device provides several options for adding the parameters weight and
height. Your administrator specifies which of the options you can use. Further
information is available here: ➔
Stopping a measurement proce-
SpO module
®
2
Indication
• Normal perfusion
• Mild perfusion disorders
Vigorous patient movements
• Poor perfusion
• Severely disrupted signal, for
example due to indoor lighting or
direct sunlight
seca SpO module
2
Motion tolerance
Adding weight and height.
pulse oximetry).
®
High
Normal
Low