Table of Contents
Advertisement
2: Installation of Customer Replaceable Components
30
6. Remove the screw located on the inside of the system's upper panel. See Figure 2-10
for the location of the screw.
Removing Power Supply Inside Screw
Figure 2-10
7. Pull the power supply out of the system, avoiding any physical contact between the
power supply and any system component.
8. To install the power supply, keep the system resting on its right side.
9. Carefully place the power supply into its housing, and push it into place.
10. Replace the inside screw shown in Figure 2-10.
11. Replace the two rear screws shown in Figure 1-2 on page 3.
12. Connect the power supply cables to the system board, the hard drive(s), the
CD-ROM drive, and to the floppy disk drive. Refer to Figure 2-11 for the location of
the power supply cable connections.
Power supply
inside screw
007-4263-001
Advertisement
Table of Contents
