Installing And Removing Memory Modules - Silicon Graphics 230 User Manual

Installing and Removing Memory Modules

007-4263-001
The three 168-pin sockets onboard support SDRAM-type DIMMs. You may install
64-MB, 128-MB, 256-MB, or 512-MB (single and double density) DIMMs for a maximum
1.5-GB system memory.
Note: Only 3.3 volts SDRAM should be used; 5-volt memory devices are not supported.
This system board supports 133 MHz ECC registered SDRAM only.
Warning:
Do not use both 100 MHz and 133 MHz SDRAM together. This might
cause your system to malfunction. For a qualified DIMM vendor list, please call for
support.
Each of the DIMM sockets is independent from the others. This independence allows you
to install DIMMs with different capacities to form different memory configurations.
System Component Installation
69