Cabinet; Power Switch; Cabinet I/O Panel - Silicon Graphics IRIS Workstation User Manual

IRIS Workstation Specifications
• 1 25-pin plug for connecting a control cable from the Cabinet to the
Monitor.

3.5 Cabinet

There are two control panels on the back of the IRIS 1400 Cabinet: an I/O Panel
and a Power Panel. A
system.

Power Switch

The switch for the IRIS 1400 Workstation is located beside the tape drive
Power
slot on the front upper-left corner of the Cabinet.

Cabinet I/O Panel

The Cabinet I/O Panel has ports for connecting the Cabinet to the Monitor and
a host computer (see Figure 3-4) and several control and indicator features.
•
Port 1
between the Monitor Back Panel and the Cabinet I/O Panel.
•
Port 2
lines.
• 1 15-pin D socket labeled
an Ethernet drop cable.
• 1 BNC socket labeled
connecting the Cabinet and the Monitor.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
• 1
Reset
button resets the processor which in turn resets the rest of the
system. After the
Workstation must be rebooted. This switch and the
correspond to the
Panel on the Monitor. Either button may be used.
Version 1.0
switch controls power for the IRIS Workstation
Power
is the receptacle for the control cable that is connected
, and
Port 3 Port 4
Green
Blue
button is located on the Cabinet I/O Panel. Pressing this
Reset
Reset
IRIS WORKSTATION GUIDE
are available for RS-232 or RS-423 serial
connects the IRIS Workstation to
Ethernet
is a port for the video sync cable
Sync
is a port for transmitting the red video
Red
is a port for transmitting the green video
is a port for transmitting the blue video
button has been pressed, the IRIS
button and
Halt
Halt
light on the IRIS Control
11
light