Silicon Graphics 230 User Manual page 102

4: Setup Utility
86
Table 4-4 (continued)
Parameter Description
Cylinder Specifies the number of cylinders of your
hard disk, This can only be modified if
Device Detection Mode is set to Manual. If
Device Detection Mode is set to Auto, this
parameter will be set by the system.
Head Specifies the number of heads of your hard
disk. This can only be modified if Device
Detection Mode is set to Manual. If Device
Detection Mode is set to Auto, this
parameter will be set by the system
Sector Specifies the number of sectors of your
hard disk. This can only be modified if
Device Detection Mode is set to Manual. If
Device Detection Mode is set to Auto, this
parameter will be set by the system
Size Specifies the size of your hard disk, in MB.
This can only be modified if Device
Detection Mode is set to Manual. If Device
Detection Mode is set to Auto, this
parameter will be set by the system
Hard disk size When set to Auto, the BIOS utility
> 528 MB automatically detects if the installed hard
disk supports the function. If supported, it
allows you to use a hard disk with a
capacity of more than 528 MB. This is made
possible through the Logical Block
Address (LBA) mode translation.
However, this enhanced IDE feature works
only under DOS, Windows 3.x, Windows
95, and Windows NT 3.5 and above. Other
operating systems require this parameter
to be set to Disabled.
IDE Drive Parameters
Option
User Input
User Input
User Input
User Input
Enabled
Disabled
007-4263-001