Replacing Front System Fan; Figure 2-14 Removing Front Fan Screw And Releasing Clips - Silicon Graphics 230 User Manual

Replacing Front System Fan

007-4263-001
Follow these instructions to remove the front system fan:
1. Remove the side panel and the bezel as shown in "Pre-installation Instructions" on
page 16.
2. Disconnect the front fan cable from the system board.
3. Remove the front fan screw located on the front panel. Figure 2-14 shows the
location of the screw.
4. Release the three retaining clips shown in Figure 2-14 by pushing on one clip at a
time while holding the fan plastic frame inside the chassis.
Clip
Clip
Front fan screw
Clip
Removing Front Fan Screw and Releasing Clips
Figure 2-14
5. Once the three clips are released, the fan plastic frame can be removed from the
system.
Replacing Fans
35