Monitor Back Panel; Cabinet; Power Switch - Silicon Graphics IRIS Series Terminal Manual

IRIS Terminal Specifications
• 1 button labeled
must be rebooted each time the
Monitor Control Panel
The Monitor Control Panel has several features for adjusting the Monitor (see
Section 6.6) and a
Figure 3-2).
• 1 knob labeled
Turning this knob clockwise increases the Monitor's brightness.
• 1 knob labeled
clockwise increases the Monitor's contrast.
• 1 button labeled
• 1 light labeled
switched on and most of the Monitor is operating properly.
• 1 switch labeled

Monitor Back Panel

The Monitor Back Panel has several ports that connect the Monitor to the
Cabinet (see Figure 3-3).
• 2 BNC sockets labeled
connection from the Cabinet.
• 2 BNC sockets labeled
• 2 BNC sockets labeled

Cabinet.

• 2 BNC sockets labeled
Cabinet.
• 2 BNC sockets labeled
Cabinet.
• 1 5-amp fuse.
• 1 10-amp 100/120 volt power plug provides power for the Monitor
from the Cabinet.
• 1 25-pin plug connects a control cable from the Cabinet to the
Monitor.
Version 1.3
resets the IRIS Terminal. The IRIS Terminal
Reset
switch for controlling power for the Monitor (see
Power
Brightness
adjusts the white levels. Turning this knob
Contrast
Degauss
indicates that power for the Monitor is
Health
controls power for the Monitor.
Power
V D
R
G
B
IRIS TERMINAL GUIDE
button is pushed.
Reset
adjusts the white and black levels equally.
demagnetizes the Monitor screen.
are used for the video sync
Ext Sync
are not used.
receive the red video signal from the
receive the green video signal from the
receive the blue video signal from the
9