Securing Web Access To The Xt Series - Avaya XT Series Deployment Manual

Securing your XT Series
2. Select Advanced Settings or Administrator to set or change the administrator's PIN
code.
3. Select Basic Settings to set or change the user's PIN code.
4. Enter the current PIN code. The default PIN is 1234.
5. Enter your new 4 digit PIN code, and re-enter if required.
6. From the web interface only, select Save.

Securing Web Access to the XT Series

About this task
By default, you can connect remotely from the web to your Avaya Room System XT Series. You
can disable remote web management of the XT Series completely, or restrict it so that only a
range of IP addresses can access this device.
This section also shows how to change the web access username and password. We strongly
recommend that you change the default credentials first time you access the XT Series remotely,
described as part of the procedure below.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
To modify the PIN remotely, you must be connected via HTTPS (see below).
August 2020
Figure 113: Set PIN Code
on page 151.
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
232