Configuring The Screen Saver To Start Automatically; Configuring Monitors - Avaya XT Series Deployment Manual

Configuring the Screen Saver to Start Automatically

About this task
The screen saver helps to protect the endpoint's monitor from burn-in without switching it off. For
Avaya XTE240 with computers running the Avaya Room System XT Control utility, the screen
saver does not activate when using the computer while the endpoint is dormant. In this case, use
the computer's screen saver functionality.
Procedure
1. Access the screen saver settings. From the endpoint's main menu, select Configure >
General. From the XT Series web interface, select the Basic Settings tab.
2. Set the time after which the screen saver automatically starts on the display in the Screen
Saver field.
3. From the web interface only, select Save.
Related links
Configuring Basic Settings with the Quick Setup Wizard

Configuring Monitors

About this task
After you connect one or two monitors to the HDMI ports on the Avaya Room System XT Series,
you can configure the number of monitors, their resolutions, and the allowed video layouts.
However, the Avaya XTE240 only works with its own single monitor at a fixed resolution of 1080p.
Video layouts often require overlapping images when there are more video streams than available
monitors. For example, when your endpoint is disconnected, there is just local video stream which
fills the screen, or a local presentation from a PC. If you call another endpoint with no
presentation, there are two streams: the local and the remote video. If you add (send or receive) a
presentation, there are now three streams.
The available layouts depend on the number of monitors.
with presentation
view shows a video image in the main screen, with an additional smaller image overlapping in the
corner. The PaP (Picture and Picture) view shows up to three images of the same size. The PoP
(Picture out Picture) view shows up to three images of different size, presented side by side,
where the image on the left is larger than the two smaller images on the right. For more
information about video layouts, see Avaya Room System XT Series User Guide.
August 2020
on page 122 shows the layouts for a single monitor. The PiP (Picture In Picture)
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
on page 110
Figure 54: Single monitor video layouts
Configuring Monitors
121