Connecting A Computer To The Xt Series Using The Hd1 Port - Avaya XT Series Deployment Manual

Connecting a Computer to the XT Series using the HD1 port

About this task
Instead of using the DVI port, you can use HD1 input for presentation content while using HD2 for
a live camera. If you use HD1 for the presentation content, you can display a resolution up to 4K
Full HD. In this scenario, you must connect the first camera to the HD2 port of the XT Codec Unit
and connect the cable for serial control and power to the horizontal connect (VISCA port). You
must connect the computer displaying the presentation to the HD1 port. An HDMI cable or adapter
is needed. HD2 is automatically configured for the default live camera and audio is disabled for
that port.
Procedure
1. Connect the first camera to the HD2 port and connect the cable for serial control and
power to the horizontal connect (VISCA port).
2. Connect the computer displaying the presentation to the HD1 port.
3. Set the computer's resolution by accessing the operating system graphics settings.
4. Select your screen resolution and refresh rates from the list of supported settings. For
more information, see
rates on page 83.
Table 10: Supported computer monitor resolutions and refresh rates
Name
(YCbCr 4:2:2; RGB formats not
supported)
(digital only)
WSXGA
August 2020
Figure 45: XT7100 with 4K Input for Presentation Content
Table 10: Supported computer monitor resolutions and refresh
Resolution
3840 x 2160
1920 x 1080
1600 x 900
1440 x 900
1400 x 1050
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Connecting a Computer to the XT Series
Digitial Refresh Rate (Hz)
30, 25, 24
60
60
60
60
Table continues...
83