Avaya XT Series Deployment Manual page 125

6. Enter the field values as described in
Table 21: Configuring the video layout
Field Name
Multi Image Mode
Multi Image Type
PIP - Position
PIP - Rotation
PIP - Size
7. From the web interface only, select Save.
Related links
Manually setting up the XT Series
August 2020
Description
Enable PIP, PaP or PoP video layouts, depending on the number of video streams
available (see Figure 54: Single monitor video layouts with presentation
• <auto > enables PiP, PaP or PoP only when the number of video streams is greater
than the number of available monitors. The order of the video streams is set
automatically, with precedence to the presentation video streams.
• On always enables PiP, PaP or PoP when at least two video streams are used.
When you are using two monitors, PIP can be forced only if there are at least three
different video streams.
• Off always disables PIP, PaP and PoP.
Limit the video layouts available to users:
• auto enables PIP, PaP and PoP layouts. Press the Layouts
remote control or the Pip key on the advanced remote control, to switch between
PIP, PaP and PoP.
• PIP enables only PiP.
• PaP enables only PaP.
• PoP enables only PoP.
If you are using a 4K UHD or 2160p (3840x2160) monitor, Multi Image is set to PaP,
by default.
Set the position of the small overlapped image on the monitor: upper left, upper right,
lower left, or lower right.
Enables/disables image rotation and controls the direction in which the image rotates.
End-users press the Layouts
• Fixed blocks image rotation (not available for Avaya XTE240).
• Clockwise rotates the overlapped image clockwise.
• Counterclockwise rotates the overlapped image anti-clockwise.
Select from Small or Medium sizes.
on page 105
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Table 21: Configuring the video layout
key to activate image rotation (if enabled).
Configuring Monitors
on page 125.
on page 122).
key on the simplified
125