Avaya XT Series Deployment Manual page 56

Setting Up the XT Series Hardware
left channel audio from its left microphone, and the right channel audio from its right
microphone. The third microphone of the Avaya Pod is disabled when using stereo.
If you deploy the One-way Microphone Pod, note it has a limited three meter 180° range, so
be sure to place all participants on one side of the microphone. The Three-way Microphone
Pod picks up sound up to three meters away at all angles (360°).
Position the Microphone Pod as far as possible from loudspeakers and other noise sources.
Do not place paper or other objects in front of the Microphone Pod.
For large conference rooms, you can deploy two Microphone Pods, distributed evenly on the
table. When using the Avaya Pod to receive stereo, the cascading feature is disabled but you
can still use the second pod to mute/unmute the XT Series. In very large rooms, consider an
audio mixer to add as many microphones as needed. For more information, see
Microphone for Your XT Series
• Position of the XT Codec Unit
Place the XT Codec Unit on a horizontal surface which stands firmly on its base. The surface
must be dry and free of dust, oil and other residues.
Position the XT Codec Unit and the camera so that their front panel infra-red (IR) sensors are
visible by someone holding the XT Remote Control Unit. If the XT Codec Unit is in a cabinet,
the XT Remote Control Unit sends to the main camera's sensor which relays to the XT
Codec Unit.
August 2020
Figure 20: Placing the Microphone Pods
on page 73.
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Choosing a
56