Upgrading The Software Using A Usb Drive - Avaya XT Series Deployment Manual

3. Download the upgrade package from the Avaya site to the computer.
The XT5000/XT4x00/XTE and XT7000 have two separate packages.
4. On the computer, launch the upgrade file.
5. Click to accept the license agreement.
6. Enter the IP address of the XT Series in the start screen and select Start.
The upgrade is transferred to the XT Series.
Caution:
After download begins do not shut down the XT Series until download is completed. At
the end of the update, the system reboots automatically.
7. The upgrade procedure may automatically continue after the reboot, and therefore reboot
again. Wait a few minutes to ensure that the upgrade procedure is completed.
Do not turn off the XT Series before the upgrade procedure is completed.

Upgrading the software using a USB drive

About this task
Your Avaya Room System XT Series can be updated by a USB drive containing the firmware.
Before you begin
Check if a later version is available by accessing the Avaya site as explained in
Series on page 201. If a later version is available, download it and copy to the USB drive.
Procedure
1. Turn on the XT Series and wait for the menus to appear.
2. Insert the USB drive into one of the USB ports on the back panel of the XT Codec Unit.
The upgrade procedure begins automatically.
Caution:
Do not shut down the XT Series until the upgrade has completed.
August 2020
Figure 100: The USB ports on the back panel
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Updating the XT Series
Updating the XT
205