Configuring The Screen Saver To Start Automatically - Avaya Scopia XT Telepresence Deployment Manual

Table 11: Configuring time zone related settings
Field Name
Time zone list
Enable daylight time
Start (dd/mm)
Stop (dd/mm)
3. From the web interface only, select Save.
Related links
Configuring Basic Settings with the Quick Setup Wizard

Configuring the Screen Saver to Start Automatically

About this task
The screen saver helps to protect the endpoint's monitor from burn-in without switching it off. For XT
Executive with computers running the Avaya Scopia
activate when using the computer while the endpoint is dormant. In this case, use the computer's
screen saver functionality.
Procedure
1. Access the screen saver settings. From the endpoint's main menu, select Configure >
General. From the XT Series web interface, select the Basic Settings tab.
January 2017
Configuring Basic Settings with the Quick Setup Wizard
Description
Select the time zone to which the system belongs.
Choose whether to enable daylight savings time.
Set the day and month to indicate when daylight saving
time starts.
Set the day and month to indicate when daylight saving
time ends. If this is earlier than the start time, it assumes
the following year.
®
Figure 52: Configuring screen saver settings
®
Avaya Scopia XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
on page 51
XT Control utility, the screen saver does not
[1...96]
63