Honeywell Enraf 1010 CB Programming Manual page 91

Authorisation Entry Mode
SCREEN 10-3
SCREEN 10-4
SCREEN 10-5
SCREEN 10-6
10 - 5
3. Press Enter to edit the currently displayed index number.
Use the Cancel key is used to move from Personnel ID entry to
Vehicle ID entry (if required) or to exit Edit ID's: if only personnel ID
is enabled, pressing Cancel exits the EDIT IDs menu; if both
personnel and vehicle iD is enabled, pressing Cancel displays
Vehicle ID entry and pressing Cancel again exits the EDIT IDs
menu.
The instrument displays one of the following messages, depending
on the type of authorisation media, where 'n' is the index number.
Type = PIN
Authorisation
Authorisation Type = TOUCH KEY
Authorisation Type = RF ID
Authorisation Type = NexWatch
4. Change the current ID number by one of the following methods:
• Press Cancel or Clear to remove the current ID Number.
• Touch the ID media onto the ID reader
• Type in the ID number via the numeric keypad
5. Press the Enter key to save the currently displayed ID number.
The instrument displays the index number and ID. Return to step 2.
10.3.2 Erase ID Bank
Once selected and the Enter key pressed, the selected ID bank is
deleted after the operator responds to a confirmation prompt.
Model 1010 Application Pack CB
Programming Manual
EDIT PIN #N EDIT PIN #N
XXXX XXXX
ENTER TOUCH #N ENTER TOUCH #N
============ ============
ENTER FACILITY & CARD #N ENTER FACILITY & CARD #N
============ ============
ENTER NEXKEY #N ENTER NEXKEY #N
Part No.: 4418024 - Rev. 1