Honeywell Enraf 1010 CB Programming Manual page 61

Metering Lines (4)
Meter n
Density correction
Meter n
4mA Density
Meter n 20mA Density The density that corresponds to a 20 mA reading from the density probe
6 - 7
Enter a value in the following range:

4 mA Temp Setting to 20 mA Temp setting
(Only if Temp. Sensor = 4-20 mA)
Or

Min Error Limit to Max Error Limit (Only if Temp. Sensor = RTD)
Allows enabling or disabling the density correction.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only with volumetric load

Not available for commodity type Special (C)
Select one of the following options:

Enable

Disable*
The density that corresponds to a 4 mA reading from the density probe
associated with this metering line.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if density correction is enabled.
Enter a value in the following range:

Refer to Table 6-2.
Table 6-2: Commodity Based Density Range
Crude
Base
Units Oils
Temp
(A)
Relative
Density 60 °F 0.61120 to 1.16464
(RD60
15 °C
3
kg/m 610.6 to 1163.5
20 °C
associated with this metering line.
Constraints:

Only available when you use the Weights and Measures switch on
the instrument to enter programming mode.

Only if density correction is enabled
Model 1010 Application Pack CB
Programming Manual
Special
Refined (C -
(B) thermal
exp.)
N/A
N/A
N/A
Lube NGL and
Oils LPG
(D) (E)
0.80168 0.3500 to
to 1.1646 0.6880
351.7 to
687.8
800.9 to
1163.5
331.7 to
683.6
Part No.: 4418024 - Rev. 1
FAME
(F)
N/A
610.6 to
1163.5
N/A